Skutt Mini Scarab Kiln with Point Rest Drop Ship Item.

Skutt Mini Scarab Kiln with Point Rest

Product Specification
Phase: 1
Volts: 240
Max Temp.: 1700
Depth: 12
Opening Width: 12 Cu. Ft. 1.4 Power
Amps: 16 Watts
Copper Wire Size: 12

The software for the COE Controller was developed by Flameworker Marcel Braun to fit the specific needs of the Boro Flameworker. It can be easy as pressing Go to start working and Go twice to anneal your piece and call it a night. The Controller is programmed to heat to 1100 F but you can set it for whatever temperature you want. You can choose between the 3 preset Annealing programs or creat your own.  Marcel knows how important to know how long your piece is at he set point temperature. That is why he programmed a feature in the controller that tells you exactly that amount of time. If you dip below that temperature it waits until it is back to set point and restarts the clock. It also includes built in striking and repair programs.

The Primary Point rest is designed to slide up and down to support your rods and tubes. If your handles are extremely long we would suggest adding the Optional Secondary Point Rest which extends further out from the kiln and is fully adjustable up and down. When you are ready to anneal you slide all the point rest up tight against the doggie door to seal off the chamber. The point rest is constructed of solid brick and stainless steel for maximum life. To operate it simply loosen the the knob, slide the rest to the position desired and tighten the knob. It was specifically designed to be a one hand operation so you can hold your glass with the other hand.

All Scarab kilns are designed with a Removable Chasis which holds all the main electrical and electronic components. Just remove the screws that hold it in place and slide it out. You can even disconnect the power cord and ship the whole thing back to Skutt for testing if necessary. One of the most problematic components of kilns has traditionally been the relays. Mechanical relays have a limited life which is why Skutt has upgraded all Scarab Kilns with Solid State Relays. These relays or kept cool with a fan mounted in the side of the kiln (not necessary on the Mini and Micro Scarab because the Amps are so low).